DIP-WELL PROBE
Description
The Dip-well Probe is designed to accurately determine the position of the top of the water table. The Probe senses the water level by detecting the change in internal reflection of a light source which is encapsulated in the probe tip. This detection method gives very reliable and trouble free operation. To operate the Probe, the tip is lowered into the well and when the tip reaches the water level an audible signal is produced. The position where the cable is level with the surface is then marked, and the distance from this mark to the end of the probe is then measured. The entire unit is waterproof and is very robust.
Specifications
|
Probe |
|
| Probe Tip | Cable length 5 metres (or as required) |
| Diameter of probe housing | 15 mm |
| Construction | Fully encapsulated |
| Detection method | I.R. reflective |
| Control box |
 |
| Control box | Waterproof polycarbonate |
| Power supply | 9v Alkaline battery (e.g. Duracell MN1604) |
| Battery Life | 40 hrs. |
| Audible output | High output waterproof transducer |
| Indicator | Low battery alert |
Automatic recording
We can also supply fully automatic water table level measuring equipment, which can be set to record the level at predetermined intervals.
We reserve the right to change without notice the specifications contained in this leaflet
© A & P Chambers 2004
Quick Links
A & P Chambers Ltd
Kaluna House
Nairnside,
Inverness,
Scotland,
IV2 5BU
Telephone:
+44(0)1463 790400
Fax:
+44 (0)870 161 7442
e-mail: sales@chambers-electronics.com
